How to install Crown
How to install Crown
A web site for understanding and cutting the compound angles for Crown Molding and cornice mouldings
Solution:   Cut the crown molding in position!
Problem :   Crown molding is too difficult.
1) MEASURE SPRING ANGLE:Measure the spring angle of the moulding (usually 38°) by aligning the back of the moulding against the Miter Finder. Press the BV/MT button once. The LCD will display the exact spring angle.

2) MEASURE CORNER ANGLE: Measure the wall corner angle (usually 90°) by placing and extending the Miter Finder horizontally in the corner where the moulding will go. Press the BV/MT button again. The LCD will display the exact corner angle.
3) COMPUTE ANGLES: Press the BV/MT button a third time and the LCD will display the exact miter angle reading. Record this angle and press the BV/MT button a fourth time to display the exact bevel setting. Record this reading.
Now you are ready to quickly and accurately adjust your compound mitersaw with these two essential measurements for making the right cut the first time!

Bookmark  us so you can
find us when you feel like shopping at Amazon.
Thanks for helping!



This page last modified on Sunday, March 09, 2008

Protractors  history and info

Mark and measure in inches, less confusion for you and your partner.

Advertise on

Site specific
(protractor page)

Copyright © 1998- Alter Eagle